Multicams 2000 Series Laser machine is a
versatile platform for
full sheet cutting. The machine is available with 100, 200 or 400 WATT
lasers.The 2000 Series flying optic system is fully collimated for
uniform beam quality in the near and far field. The 2000 Series machine
can raster engrave as well as cut out various materials. The welded,
stress relieved all-steel frame insures rigidity and structural
integrity under the most demanding conditions. Drive systems are a
combination of servo driven helical rack & pinion (dual x-axis and
single y-axis) and stepper driven screw (z-axis).
2000 Series Laser Standard Features
No machine offers more standard features than the MultiCam.
- Welded steel frame construction
insuring rigidity and structural integrity.
- The gantry is made from a custom
lightweight aluminum extrusion. A gantry clearance of 1.1875 (30mm)
- The drive system will be a stepper
driven screw (z-axis). Slew speeds of 2400/min (0.2 M/sec) with 1/2
g (200 /sec2 or 61 M/sec2) acceleration are expected with a maximum
cut speed of 1200/min (0.5 M/sec) at a +/- 0.001 (0.03mm)
repeatability. Raster speeds up to 1800/min (0.15 M/sec) using up
to 256 gray scale with up to a 1200 DPI resolution. The linear
guides for the x and y-axis are a high-speed track roller guidance
system from Star. The z-axis uses a linear ball bearing rail, also
- Synrad is the major laser supplier.
- The power ranges are 400 watts
(water cooled), 200 watts (water cooled), and 100 watts (air
Chillers from Koolant Koolers are included.
- The flying optics system is provided
by Laser Mechanisms. The optical focal lengths available are 2.5
(63.5mm), 5 (127mm). The standard option is 5. Each system will
include a red laser diode pointer to aid in the setup of the optics
and for material alignment. A beam collimator is used to insure a
consistent beam diameter thru the full range of motion. With the
optional capacitive height sensing the z-axis will react to material
height changes on the fly while cutting. This system will work with
conductive materials only. With the addition of the optional shoe,
non-conductive materials can be cut with this capacitive